4100

Hello, I'm new here. I have a problem with my 410 loader. Nothing is responding as it should. It worked fine when I took it off in the fall and the front snowblower worked fine all winter. I can get all of the functions to work on the loader, but only if I combine dump/curl movement with...

I have 4100 ford which I require to do quite bit of work to so thought be useful forum to use. As seems informative and friendly unklike others

Hello all and belated Happy New Year ! My 1989 4100 hydro will not start in below 30 degrees. The dealer want 300 for just the parts alone. Then they want to install it in the absolute worst area possible. My question can you use the relatively easy to access 1 in NPT opening on the opposite...

I had been mowing for an hour when it suddenly died. No dash lights, nothing. I found that the 10A fuse was blown. I replaced it, started right up, but when I engaged the PTO switch, the fuse blew again. Later I installed a 7.5A fuse and mowed for about 30m before the fuse blew. Hydraulic...

Currently I have 12.4-38 rear tires on my 71 Ford tractor and would like get recommendations on tire sizes. I use the tractor on my 10 acres to do yard work, brush hog field, removing brush/little trees ...etc. Would like to go wider and possibly turf tires. I know I will need to change rims...

Last remaining molded in spring retainer hood slot finally finally broke. First one failed in 2005. Without either of the two springs attached nothing holds the fuel door lid in place; the hing assembly is open on top. Lid promptly becomes dislodged and falls off the hood of the running...

Trying to get a value to sell my Ventrac 4100 - 31hp vanguard - 3pt. Needs some work. Hydraulic leaked some over winter. Gauges in op - tach work sometimes. Some play in center pivot.

I have had my 4100 since 1999. Bought it new. The tractor has always been hard to start in cold below 30 degrees. I have replaced the glow plugs twice. Both relay's also. I now pull up the pto button and turn and hold the ignition switch for 45 seconds. Push button down and turn to start...

Today, while plowing, the linkage between the lower lift arm and our Ford 4100N (Cabine) tractor broke (see picture). I did come across a replacement part (Shaft, Lower Link arm Support. Ford - Histoparts), however, I'm unsure how to replace it. Would it mean dismantling the entire rear axle...

Hello readers, I am at a dead end. With warm weather finally at the house. I decided to swap engines from the 4100 gear driven ( rear end went out ) and the 4100 HST ( Middle piston went after a loaner used ether on it.) Simple enough swap. Both engines would crank and run. A few days ago I...

My son was moving some stuff around the yard, tractor was running fine, he put it in neutral (it's a hydro) and when he got off the seat it died. Turn key and no crank. Here's what I've tried/learned so far: Turning on the key the dash lights up Turn key to start position and nothing happens...

Hi- I need help finding the governor spring code for my cav pump It has dpa numbber; 3233F641 cheers Svenn