Search results

Results 1 to 10 of 10
  1. E

    1710 popping out of reverse

    Hi Mgoldman, Here is my 1710 transmission cover: The U-joint on the right hand side of the picture is the problem. Here is the U-joint linkage: Here is the transmission with the cover off: The gears look good, and the shifter yokes are not sloppy at all. You can see inside the...
  2. E

    1710 Injection pump oil?

    Top view, looking down on the pump. Fill plug is beneath the left clamp holding the two fuel lines. Picture taken right after the new fuel line with a bit of a loop just installed. Hopefully, it now has a nice coating of dust like everything else.
  3. E

    1710 Injection pump oil?

    Hi Fedup, On my 1710, the item #34 was covered by the fuel hose between the filter and the pump. I put a longer hose in with a loop to gain access to the fill plug. Says to dump a few ounces of oil in, but no mention of draining. Read up a bit more. Says 2 ounces. Other threads say to remove...
  4. E

    Ford 1710 Priority valve leaky

    Cleaned up a bunch of grime and slime. Used foamy engine wash, scrub brushes, floor stripper detergent. After it was mostly cleaned up, I turned on the engine for just 1 minute. The leak squirted a half-ounce or so of oil in that short time. Took that mess apart. The o-rings had flat spots...
  5. E

    Ford 1710 2/4 wheel drive and hydraulic oil dipstick cover gasket replacement

    So, I have been driving this tractor around for a few years, when it is warm, I see bubbles forming from under the 4 wheel drive shift lever. Blown gasket? Take the cover off, and see that the factory gasket was torn and crimped from the start. The hydraulic oil in the sump looks a bit dirty...
  6. E

    Ford 1710 3 point hitch piston seal

    Getting read for fire abatement here in Southern California. Finally getting around to putting a new seal on the 3 point piston. If I dropped the throttle to idle or shut the engine off, the attachment would drop. 3 point hitch piston pulled out. The seal on the piston was just crumbs...
  7. E

    Ford Tractor photo thread, lets start one!

    Hi TotalNoob, Looks like something is wrong with your 1710. It is too clean. Here is mine getting ready for weed clearance.
  8. E

    How can I get rid of that pesky "Sign up now" popup?

    Came to the site to read up. Created a login. Occasionally just check in now and then to see replies. I get that dammed "Sign up now" popup every 3-5 minutes. Very annoying. Is the only way to get rid of the pop up by either signing in, OR how about going over to Discussion Forums - Yesterday's...
  9. E

    What is this and how do I fix it?

    Go to www.newholland.com Select agriculture Upper right "Parts Store" Find Parts By Model Search for Model, enter 1710 Select 1710 3 Cyl Compact Tractor Front Axle & Steering 03F02 Power Steering Tubes 1510 & 1710 Here is an invoice I got from my local New Holland dealer. Parts are the 3...
  10. E

    TODAYS SEAT TIME

    Discing weeds in Southern California, almost ready for fire inspection. Ford 1710 with 770A loader. Ford 202 Disc Harrow. Farmer tan included, but not shown. Eric O (Click for larger image)
Top