Search results

Hi i have a massey ferg 65 and cant find any info on hyd remote overhaul cant find any images of valve remote When rod was pulled out of remote body there was a oring in valve body On the rod itself was a clip on end then an oring but there was no orings on the other 3 grooves possibly...

Hi i have a massey ferg 65 multipower and need a new hyd pump my question is does the 65 pump fit the multipower 65 there is a difference at the front and top which is bracket for aluminium block to sit on and a cog on front which i removed and looks like i could fit it on new pump parts...

Hi i have a massey fergason 50A backhoe and i am after seals for 7 lever hyd valve body Thanks in advance Ted

Hi everyone seems a very good and informative forum Cheers Fendmat

Hi does any one in australia know where i can get o ring kit for massey ferg 50A back hoe with 7 spool hyd levers Tried sealco and othetrs but it appears all these o rings are square not oval Thanks in advance Ted

Hi i have a massey 50A backhoe cant get the stabalizer leg to retract the lever will allow leg to go down but when you pull lever back to retract it goes to center then wont go any further as if it is seized every other control arms work perfectly Cheers Ted

Hi i have a massey ferg 50A backhoe boom cyl have overhauled all seals but cant get the piston back in with new seals .Do you have to have some sort of ring compressor to fit ,have enclosed old seals on drum and new seals fitted on rod Thanks in advance Ted

Hi i have a massey ferg 50B back hoe and the left hand stabilizer lever will pull back but goes to center and wont go forward as if something is stuck in that direction thanks in advance ted

Hi i have a massey fergason 50A, backhoe, motor has been rebuilt and new injector pump put on has only done 30 hours since work was done and run very well was left for about 12 months and now cant get fuel to injectors have put high volume electric pump on and tapped on end of injector pump...

Hi just wondering if anyone can help with perkins A4-212 engine timing ,have got tdc compression stroke,have taken idler gear off and lined up main lines, worry is do i set gear timing marks with motor at tdc or 22 degrees before tdc and on the injector pump wheel is a 1 and 2 mark which one do...

Hi new problem have taken inj pump out and repaired made fatal mistake not putting motor on tdc (mate helped and i forgot to tell him) inj pump put in properly bled ,wont fire ,took timing case of and timed with dots still wont fire ,stripped again realigned dots on crank cam and idler wheels...

Hi i have a A4-212 perkins in a 50A backhoe just wondering if anyone knows direction of front crankshaft pulley nut, will have to use a chisel to try and undo as previous owners have butchered the nut and dont know if its l/h or r/h cheers Ted

Hi i have a massey ferguson 50A back hoe on the hyd lever for lifting the stabilizer leg in and out the lever works only one way you can feel the spring tension when you push one way but when it returns to centre it wont move the other way everything else hyd wise works perfectly Kind Regards Ted

Hi i have a massey ferguson 50A backhoe ,and i cant get the gland nut on the lift ram to undo ,have used oxy ,loctite freeze and 9ft bar with stilson,the tilt ram didnt have a threaded gland but a wire internaly through small hole,and the rear bucket ram had a threaded glan nut but it came apart...

Hi, i have a massey ferguson 50A back hoe model MF50 A 837270 hyd stopped working i have replaced front hyd pump(new one) oil level is correct hyd oil is correct no leaks have cracked hose to bleed and extended rams fully in and out also disconnected rear digger only using front bucket,bucket...