Search results

My HM722 finish mower tends to leave a path of "partially" cut grass down the middle of the mower. I have put new Hi-Lift blades on it and it still does it. Grant you, it's mostly in High Range on the 4200, but why would the two outside blades cut fine and the middle be sub-par. Any thoughts...

I'm thinking about checking into using a High Performance radiator on my 4200 (4231TD) and was wondering if anybody else has gone that route. I have used them in race cars before, but their run time was much shorter than the Ventrac. I'm thinking an aluminum high flow radiator might allow me to...

Having had my 4200 (4231TD) for less than a week, I feel pretty good about having found all the grease zerks... that is all but one! The book shows a U-Joint on the drive shaft... hmmm, that would be fine IF I COULD FIND THE DRIVE SHAFT! I've been under it, behind it, inside it, but I can't...

any suggestions on where /what to buy in the way of blades for the Tough Cut? I called all three dealers nearby (if you can call sixty miles nearby) and nobody has the std. 79.0048 Double Cut, No Lift blades. Of course everyone can order them.

any suggestions on where /what to buy in the way of blades for the Tough Cut? I called all three dealers nearby (if you can call sixty miles nearby) and nobody has the std. 79.0048 Double Cut, No Lift blades. Of course everyone can order them.