Search results

Well explained.........Thanks!!!

Thanks for the response. I just doubled checked the part numbers for the blades, and the blade pin and verified those are the correct part numbers for this cutter. Your point about the shims seem to be a point to double check as I was watching when those were installed, and there was appeared...

I had the blades replaced with oem 57189KT blades and hardware, by an experienced tractor mechanic. With the new blades on, PTO engaged, it is generating a lot of metal to metal type noise. When checking the blades I notice a lot of play in the up and down motion in the blades.......is this...

I have two of the manual valves on my 3 pt spray rig, and they would not shut off properly. I was advised it was a simple operation to remove the "stem" and install a new kit (AA6B). After removing the stem, I discovered it was different from the diagram ---- as the stem I removed appeared...

I need a (LH) lower lift arm from a Kubota L3130 or L3430 (L3240, L3540 may possibly work). I have contacted All States Ag Parts, and West Kentucky Tractor Parts, without success. I would really appreciate any recommendations or referrals to help in locating this.

I have an area approx 1 acre in size (new fill dirt) that needs to be seeded with bermuda. So far I have: Had a soil test done, and will be following those recommendations Soil is weed free, and has been tilled and leveled Most of the instructions relate to smaller areas......till, level...

In addition to the obivious......cleaning/lubricating the metal pto shaft (tractor to implement) and pto spline at the tractor, here is what I did that make a world of difference in ease of hookup: 1. Replaced the twist turn or pull to release yoke to that of the older push pin style.....cost...