Search results

I found the problem under the floor panel. The wire going to the PTO lever was cut. Wiring repaired and the starter circuit now works great! Thanks for all the help.

Does that require splitting the tractor? I had a thought last night about an old CORVAIR transmission I worked on years ago. I think it had a bolt that held a ball bearing and a spring in tension against something in the gear box. Is that technology still used nowadays? I really don’t want to...

I’m trying to find out why my 8560 started popping out of reverse. All linkages appear to be operating correctly. I tried adjusting it a little to extend the reverse position. That resulted in the forward position popping out as well. I see no cable only steel rods for the linkage. What is...

Safety switches was on my radar. There is plenty of battery to crank the engine over. There is also good voltage at the ignition switch. Turning the key on powers up all the engine lights. As I mentioned, the jumper from the battery cable on the starter to the small terminal on the starter relay...

8560 will not start with key switch. I can jumper the battery wire on the starter to the small solenoid wire and it will crank. And if the key is in the on position it will start and run. All fuses check with voltage on both sides. I have also put a jumper on the hot ignition switch wire to the...

Anyone know how the forward/reverse shaft inside the case actually works? My shaft turns but does not engage forward or reverse. Apparently whatever is on the shaft inside the case is broken?

Here are some pictures that I sent you the pm about.

Hello forum. I have recently purchased a Yanmar 4300 non-running tractor with loader. Compression was low. I pulled the head and replaced all valves, 3 new exhaust seats, lightly honed cylinders and replaced rings. Ring gap was still within factory specs. Compression was around 200 psi before...