Search results

I would like to add "The Thumb" grapple to my CK2610, but would like to read comments from those of you who have purchased one on how happy you are with it. Thanks for your input. PMH

Most of my work is off-road, so I normally leave the tractor in four wheel drive. However, recently I have had to travel a half mile or so to another location, over paved roads. I have discovered that it is extremely difficult to change to two wheel drive. Is there an adjustment to the linkage...

I have a Ck2610 that will have to remain outside in the sunshine (and rain) for the next six to eight months until I can get a shed built for it. I would like to be able to tilt the seat forward so that it lays against the steering wheel. This would protect it from UV light and prevent rain from...

The drawbar on my new CK 2610 has a 1 1/8" diameter hole. This is far too large for the standard Category 1 pin. In fact, the largest hitch-pin I could find on the internet (Messicks, Tractor Supply Company, etc.) was 1" diameter. So, some questions: 1. Is this a standard size hole? 2. Can I get...

I would like those of you who have LS tractors (especially those with MT series) with the 12 speed synchro transmissions to give me feedback on your experience and what you like/dislike about them. Some background: I have been looking into the purchase of a small tractor/loader. I have...

I知 planning to buy a 25 HP tractor, with loader . I知 looking at Kioti, LS, New Holland, Massey Ferguson, Kubota. Each has a dealer within two to three hours drive. From what I have read on this site, having a good dealer close by is important, a major factor in deciding what tractor brand to...

Hi All, I bought my last tractor back in 2012. I first bought a L4600. It had a three point hitch that was so jerky that it was almost useless. I traded it for a L4240, which was a lovely tractor. I wish I had it still. However, I moved from mountains of Colorado to mountains of North Carolina...

I have just installed a 3rd function capability on my L4240. I would like to slow its action down some, to gain better control. Has anyone installed adjustable flow limiters on this or a similar tractor? If so, where did you install them, and where did you buy them? Thanks for the help. PMH

I was out working with my L4240 today when I noticed the oil pressure lamp was on. I immediately stopped the tractor. Oil level is fine. Oil is nice and clean. The tractor has 112 hours on it. I changed oil and filters at 50 hours, just recently pulled 100 hour maintenance. I let the tractor...

I ran across a picture of the Kenco triple tine rock grapple. Have any of you used one, and what is your experience? It looks like a really clever idea. Thanks for your input.