Search results

Hello all, I am hoping to get some feedback from people that use an over run clutch/coupler (ORC) on their tractors. I like the idea of saving the pto brake on shut down but was wondering if there is a down side to using them. Added stress or something else? Also would like to know which ones...

My MX4700DT front wheel assisted tractor seems to have a slow leak at the bell housing pin that sticks out at the bottom. The thing that I find a little perplexing is that the fluid has a red tinge to it much like transmission fluid. It does not look like engine oil, it is far too clean for...

Came across this Kubota lubricant chart from another thread here on TBN and was looking at the GL-4 requirement of the front axle 80w90 gear oil alternative to the UDT. As I recall the 80w90 I used was a GL-5. As I did a search I am finding it hard to locate GL-4 80w90 at my local stores. From...

Just did the first hydraulic filter change on MX4700 with manual transmission. Owner's manual states 400 hours but I decided to do it a little early at 200 hours. Cutting the paint at the seam helped a lot, filter came off no problem. Fluid shows glimmers of very fine shavings but not extreme...

Hello all! Was wondering if anyone might know what the front to rear axle ratio might be for Kubota MX4700/5100? Seems like important information that is not contained in the owner's manual. Or at least I have not been able to find it.

Hello everyone; I have been considering changing my front axle from UDT to gear oil. Either 80w90 or 75w90 synthetic. The manual says that I can use 80w90 as a replacement. My question is do I have to flush out the UDT and then do a final fill with gear oil or can I just drain and fill with the...