Search results

I am looking for information on where I might can find transmission for Gehl baler. Can these be overhauled? I was baling the other day and I noticed the area where my finger is started smoking and got real hot. All States Ag Parts did not have one. If it can be repaired, how do I get the clamp out

Anyone know how adjust clutch on MF 231S to keep the PTO from grinding when trying engage it?? Help plz

My MF 231S is leaking diesel from the priming pump when running. It is coming out of small hole on the side. It is had to tell from the pictures. I wish that it was some type of way to upload a video. It just start this today. It will run fine and I can do whatever I need to do with it. I just...

I have another issue with my Ford 5000. I use it for baling round bales of hay. The other day it was turning good and all of sudden it just stop working while engage. The next morning I tried it and it start working. I haven’t try to bale hay with it again. What could cause this to happen in...

I just purchase Ford 5000 tractor. I am trying to figure out how to get the 3 point hitch to work to go up and down. The old owner said that I have this lever out but it is not moving

What is best way to clean diesel tank? I have had my filter that goes on drain valve clog up within 2 months. It got a lot of sludge in tank.

I have Gehl 1850 with TDC on it. I am having trouble getting the hay to start rolling once it start feeding into it. I have it at the right RPM. I have tried to adjust the gate roller and the bale starter roller to factory setting as mention in manual. I also tried to adjust the pressure on the...

I have Ford 5000. I am trying find easiest way to install the brake rod seal boot on this tractor. I caught hell trying get old one out but now new one won’t go in. I tried to press it in but still not luck. Have anyone tackle this issue and can help me out???? Plz

I have MF 231S. I replaced the fuel filter. I used the prime pump on opposite of engine to full filter with diesel. I also breed line and call myself getting air out of line. It cranked but it still have air in line. How can I bleed rest of air in line out? It will go died but it will crank...

How can I get these lines off? They are extremely hard to break a loose. I have pour brake fluid around threaded part. Is there any easy way? I know that I should not use vise grips. I have tried flare tube wrench also.

I am still having issue with splines on coupling stripping. I was wondering could I run auxiliary remote from top of 3 pt lift on tractor to operate FEL. I tried to post video to show more details. It would not let me upload but I hope pictures help. I also drill hole in coupling and pump shaft...

Do any members happen to have picture of external auxiliary pump that I can hook my FEL up to instead of onto of them 3point lift. I want it to independently.

The splines in coupling end has stripped. I am hoping that someone could help me find shaft or coupling. I have part #109694M1 but it's not pulling up anything. I got this number from MF dealers but just for the coupling itself is over $100. I attach pictures of coupling. This goes on front of...

The splines in coupling end has stripped. I am hoping that someone could help me find shaft or coupling. I have part #109694M1 but it's not pulling up anything. I got this number from MF dealers but just for the coupling itself is over $100. I attach pictures of coupling. This goes on front of...

I have MF 231S with FEL. The hydraulic pump that operate the FEL just stop working, Pump is located in front of tractor as noted in picture. Pump has a shaft that goes into something I guess that turns with the crankcase. With the motor off, I can turn the shaft freely with out any problem which...

I have MF 231S with FEL. The hydraulic pump that operate the FEL just stop working, Pump is located in front of tractor as noted in picture. Pump has a shaft that goes into something I guess that turns with the crankcase. With the motor off, I can turn the shaft freely with out any problem which...

What would make one wheel just spin when it is under a light load? I was trying back up a 16' trailer not loaded up hill and left wheel just spin. I press the brake for that side to get traction but I never had tractor that just spin that easy. Could it something with differential?

I just purchased MF 231S with loader. 1) Do a neutral switch connect to the 2 green wires? I have to touch them together to start it. If so, can you send me photo of how it's connected? 2) Do the lever suppose to be in the up position or lie it is now? Also do it suppose to have pressure on...

I have '64 Fordson Super Dexta. I would like to know what causes my transmission fluid to turn whittish. What can I do to get all the whittish fluid out of the transmission? Will this damage anything?

I am having trouble with my pto when I engage it for example bushhogging it will disengage on its own. It will stay engage until it get in some high grass unless i raise it up. If this is the problem, how do I adjust it. The tractor is a diesel 3 cylinder. I have tried to use a heavy spring to...

I am having trouble with my pto when I engage it for example bushhogging it will disengage on its own. It will stay engage until it get in some high grass unless i raise it up. If this is the problem, how do I adjust it. The tractor is a diesel 3 cylinder. I have tried to use a heavy spring to...

I was wondering if anyone know a good website to some super dexta parts.

I have this 650 Prowler. It will turn over but will not stay crank. I have to keep priming it for it to stay crank. Once u get off the gas it will go dead. Also, the tailpipe and muffler turned cherry red while running. I put in a new spark plug and change gas with fresh gas. Has anyone...

I have Fordson Super Dexta, 3 cylinder diesel. The problem that I am having is that I can fill it with water and run it. It will start blowing water out of the little drain hole at top of radiator(near cap). The water is going somewhere. It is not any water in the oil or oil in the water to...

I have a craftsman DYS 4500. It is a 46" cut. When cutting grass with sharp baldes, one side cuts properly and the other side will cut but leaves grass half cut. The deck is level. Blades are new. The side that is not cutting right is the side that throw the grass out. Could it be something...

I am having trouble with my pto when I engage it for example bushhogging it will disengage on its own. It will stay engage until it get in some high grass unless i raise it up. I don't know if it need adjusting cause the pto handle is touching the the lift which I think is causing it not to go...