Search results

The original pump froze as I had water in the tranny/hydraulic oil. Changed the oil and filter and pump. Because this valve was stuck and the pump had more pressure (new) it sheared the first key. Replaced the key and cleared that little valve and all is good so far..

What does this screw valve do?

I recently replaced my Hydraulic pump on my 186D. (external one that pressurizes loader and 3 point) I cleaned out all the fluid and refilled. Changed spin on filter. New pump makes a slight noise. It operated the loader and 3 point ok, but an hour later it sheared the woodruff key on the pump...

My 186D will need new rear wheel as the calcium has destroyed them. Not leaking yet but it's a matter of time. Has anyone found a budget replacement? My brothers kubota has dodge dakota wheels on it I think. The yanmar bolt pattern is 6 on 4.75 if memory serves...16 inch 8 inches wide. Tires...

Mine is identical to that when attached to the tractor.

So then where would it be? It's a Yanmar 186D..on the 3 point?

Could be danfoss (vickers) 30542-6C... It's on a 650 FEL on a 186D looking for the spec sheet or information on relief valve. Doesn't have a conventional relief valve.

What's the lifting capacity of the YL-650 on a 186D with filled tires and a mower behind?

I've had my 186D a couple of weeks now and love it. I think I know the answer to this but will ask anyway. The 186D has a clutch and a 9 speed power shift tranny. When operating the loader I run into the pile and if I don't push in the clutch, the engine will stall, before I shift to Reverse...

Hey all just bought a Yanmar 186D with a KMW loader. Model is K650. Tractor has a PH8A filter remote mounted for what appears to be the hydraulic system. I know that a PH8A is a ford motor filter. Is this the proper type of filter for this application? Here's some pictures. thanks

Anyone ever tried cutting down the lugs on rice patty tires? I am going to trim mine down by an inch or so as they are tearing up my gravel driveway. Tractor is an E-14 Hinomoto 2wd with 8-18 rears. Your thoughts?

Hey all, new here...just bought a Hinomoto E14 and wondering where to get an operators manual and service manual. I have heard the operators is only available in Japanese, but Massey 205 is close. Free would be good if someone has one on .pdf Thanks