Search results

I have a land pride rotary cutter that I am having trouble finding a gear box for. I am unsure of the model but the serial number is 879470. All the gear boxes I have bought the output shaft is to short. I had tto cut the old output shaft and stump jumper off so can't get a measurement of the...

Can anyone tell me what the tractor in the upper left hand corner means?

I am looking for a Mahindra 2615 wire diagram. I have a service manual but can not zoom in on the wire diagram without distorting it.

Have a Case IH Farmall 31 that has a whinning noise when you release the clutch pedal. Once the pedal is depressed the noose goes away. I just split the tractor and replaced the release bearing.

I have a Farmtrac 535 that they hydraulics are jerky. I changed the fluid and filter ans cleaned the suction screen/filter by the left foot. It seemed to work better after changed and then I let it set for about a week and it's aherky again. I did not use it a lot after changing the fluid and...

The tractor turns over fine but only starts when you let go of the key.

So have a GC2300 with oil in the radiator. Does anyone know if this unit runs hydraic fluid through part of the radiator to help cool it ?

Have a Branson 4020R that the foot peal and levee for throttle dropped working. If you use the throttle control on the console the throttle lever on the pump seems to stick but still does not accelerate with the foot pedal or the throttle lever on the console. Any suggestions would be greatly...

Does anyone have access to a Long 560 owners manual?

I have a Long 560 tractor with a hydraulic leak from the transmission case. The drain plug and two holes in line with the axles and drain plug are on the bottom side of the case. One hole is plugged with a bolt and jam nut. The other hole is wide open and the parts manual does not show anything...

I have a John Deere 650 tractor that I was in the process of cleaning up a rusted injector pump and one of the small pins that hold the rollers in flew across the shop. Does anyone know where I can get the pin and wire that hold the pins in place ? Items 39,40,41 and 42 in attached photo.