PTO Shaft Length - minimum overlap etc

   / PTO Shaft Length - minimum overlap etc #11  
Just to illustrate that point here's the shaft after cutting 40mm off the outer and before cutting the inner. You can see only 15mm or so needs to come off.
View attachment 3539942


These are the actual offcuts. Without doubting your comments that I'll have miles more overlap than needed, I don’t see why I'd want to sacrifice an inch by cutting the same length off the inner.

View attachment 3539943
I'm going to suggest that the reason the inner is shorter is because at the other end of shaft than you're showing, if might interfere with the cross if it's turning at an angle if you leave it too long
 
   / PTO Shaft Length - minimum overlap etc
  • Thread Starter
#12  
I'm going to suggest that the reason the inner is shorter is because at the other end of shaft than you're showing, if might interfere with the cross if it's turning at an angle if you leave it too long
The inner can't pass right through the yoke and stick out the other side, if that's what you mean. The fixing pin is in the way, and is presumably what it's stopped by in my picture.
 
   / PTO Shaft Length - minimum overlap etc
  • Thread Starter
#13  
However, I make a point of leaving the safety shield exact or 5mm too long so the plastic bottoms out before either end metal does.
That's a good idea, too late for me this time. But I might mark the fully closed line on the plastic if it doesn't actually close right up.
 
 

Tractor & Equipment Auctions

2012 John Deere 7280R MFWD Tractor (A51039)
2012 John Deere...
2019 Chevrolet Silverado 1500 4x4 Crew Cab Pickup Truck (A50323)
2019 Chevrolet...
2014 VOLVO VHD DAYCAB (INOPERABLE) (A50854)
2014 VOLVO VHD...
2018 FREIGHTLINER 1085D DUMP TRUCK (A51406)
2018 FREIGHTLINER...
2008 TEREX USA LLC LIGHT TOWER (A50854)
2008 TEREX USA LLC...
2006 Volvo VNL (A51039)
2006 Volvo VNL...
 
Top