Zork's latest activity

Thanks again to all for the replies. I was able to get the bearing out using a 3 arm puller I modified to wedge between the races...it...

My Branson has a linked pedal too. It cannot be disconnected, but you can set the hand throttle at whatever minimum RPM you want, so...

Get one of these Engine Cleaning Gun Adapt the cleaning fluid pick-up hose to your hydraulic with whatever fittings it takes Adjust...

Sorry to hear this. Make sure your rear vent is not plugged or restricted and make sure the surface of the input shaft where the seal...

Any pictures?

My guy used google and found Keno Tractors in Or, had my exact 2004 3520 bucket cylinder seals- worked great. https://www.kenotractors.com/

Did you get it repaired?

There should be little to no pressure on the back side of that shaft seal. If oil is squirting out I would suspect there are problems...

Hi again, So I took the tractor apart again. I was able to get a video of the shaft spinning. It did look a bit wobbly to me. And I...

I got mine from BXPANDED ... The "Quick-On" makes swapping things a breeze ... Slide red pin in notch, pivot purple up and slide in pin...

I missed some of this. If the input shaft is damaged at the seal location with a groove it will likely leak again if the seal depth...

I removed my OEM filter assembly on my 3520 - same as your picture- because the hose fitting was leaking and after examination I...

I've got an aftermarket on mine, runs fine.

Can I use an aftermarket fuel pump 12v should be universal if I'm correct

Is there a vent in the transmission and if so, is it clean and functioning properly? My simple mechanical vent on the front axle rusted...