wirlybird's latest activity

After years of running a very similar mower with the steel straps in place and using a link much like the one pictured, no problems. I...

it is only breaking one side so it is not actually shearing them. I did use a 3 1/2 and it lasted longer but did eventually break. I...

It is fine. I completely disassemble and clean every spring, and it is checked every month. I do this with all of my slip clutches. It...

No worries! They had a good price, compared to others, but crazy shipping ... AND you can get free shipping if you spend $1000! I...

Sorry did not go that far to find out. Shipping can really tick me off...

Sorry for no updates but been out brush hogging and mowing every day. The cutter is still breaking bolts. Not frequently but is...

Was just going to order from them until I found they wanted $25 to ship the two disks. The disks are 5.5 inches in diameter and an 1/8...

Yes, and for me anyways, I select the bottom one for things like my brush hog which I want the rear to raise more when I lift it...

Yes, they do move forward from bottom to top. Tractor is a John Deere 3038E. I use the bottom hole for my brush hog so the rear will...

I'd set them as stated to start with and work from there. If it slips too much then tight 1/4 to 1/2 turn on each bolt. Same if it...

Here is what it says for my John deere.

Typically, with non-draft control 3pt hitches, the only reason to use the different pin location on the tractor side is to change how...

The RC2072 is rate 25 and up PTO HP and the landpride 1872 is rated 20 to 65 PTO HP. Of course, the more the better. I just mowed 18...

The 6 foot Frontier ran fine on the 3038E. It just left two partially cut trails where the tires are. Had to do a massive overlap to...

I would think if it were a blade issue the cut would be bad all over. I will say I don't care for the design of the JD cutters blades.