Recent content by widowmaker19

This is very helpful. A little hard to maneuver and find things but still good thank you

Yea sir at the time we were just messing with it like you said to do. Going to try careyo63 recommendations this weekend when I install ignition switch

Is it supposed to have a gap like that? I had the leaver that’s attached to hydraulic turn forward.

How far does the pin on hydraulic valve assembly need to be out ? Does it need to be making contact once lever is in down position?

Man I’ve been trying to figure out what that thing controls. What position does it need to be in? Mine is currently in up position same as the picture

Yea had a sprayer on it took it off then tried putting weight on arms. Maybe I need tap it with a sledgehammer?

Yea tried that didn’t move anything

Yes I have it turned open as far as it will go

I’m very new to old tractors and have been servicing my ym2610, was able to get tractor running and now my 3 point hitch is in raise position and unable to lower down, I changed hydraulic fluid and still not able to lower down. Any suggestions on what to do ?