Recent content by Wherewolf

I would guess that it's probably a power steering hard line - look on JDparts under the steering and brakes section for the F932 - it even shows the grommet, so I'm assuming the lines go through the frame. Looks like some of the lines are (NLA) but you could probably make new hard lines with a...

well...I've spent emails and phone calls with Concentric, all they can come up with was that it was an OEM pump - no idea as to it's specs. I had heard that it had come off a 1 lung diesel kubota around 5Kw so it couldn't have been much. Apparently it was used on tank transport trailers to move...

I have this small gear pump, but can't find any specs on it. It has a 5/8 9 spline shaft - SAE A 2 bolt mounting and a larger in port (3/4?) than out (1/2?) I would like to know the displacement / rev and (ultimately) GPM at 1800rpm. Also does anyone have any cross reference info for a direct...

Can anyone help me ID this engine? I'm looking for a model number? - all stickers and labels are gone - only thing left is a number on the injector side of the block way down low...... I was told it didn't run, but by dinkin' (and drinkin') , found a wire to the fuel cutoff has so much...

I have an engine out of a Gator, but no wiring harness - I pretty sure this is the correct VR, but I can only guess at the hookups. I have a very small 2 wire (both light blue wires) alternator. Does anyone have any better guesses before I start by trial and error and fry it? Here is what...

When I aquired this engine, it had no wiring harness or relays. I can handle the wiring for the fuel solenoid, starter, and temp/oil senders. What I'm wondering about is the glow plugs. Do I need a relay? or can I wire 12 v to a push button type switch and on to the plugs so they only heat...

Noob here - would appreciate any insight/information anyone is willing to share. Have a 3TNE68 18hp yanmar engine (abused - by former owner) and am looking for a decent source for connecting rods (2 out of 3 are bent/twisted) either new or used. I think this engine is used in New Holland...