Recent content by WarrenPFJr

I am in a similar position with wanting road privacy. I plan to make a hedge from Rose-of-Sharon with pine saplings behind them. I have a gazillion small RoS from all the seeds dropped from larger ones around the property. They grow quickly and will need a bit of trimming early on but will give...

I have a Kubota B3200 with a bh76 and I would like to put a grading bucket on it. Is that possible? Has anyone one here done that and if so where did you find the grading bucket? Im thinking maybe a 30”?

Things seem to be running fine now but in all honesty I haven't put much seat time in since the repair. This time of year i use the machine for bringing in pallets of firewood and snow removal so I have only run her maybe 30 minutes since last week. No news is good news for now. Ill post an...

Thank you all for the responses and great advice. I wound up swapping the whole fuel filter assembly based on the tech recommendation. His thoughts by the description was that air was leaking through those hoses into the fuel filter assembly at the top. By replacing the whole thing, it stuttered...

I spoke to a repair guy at the dealership this morning. He said a common problem with my machine fitting the description of my problem has to do with the assembly on the fuel filter. Where the hoses attached to the top of the filter at the inlet outlet sometimes that part wears or wiggles loose...

Hey all, I have a B3200 Kubota and I’m having issues keeping the machine running. It will start, it will idle for a few seconds and then quit. Sometimes it will run for a minute or two so I can move it around but then it stalls out again . it does this over and over. It’s like it’s not getting...

New injector is in and I’m back up and running! Thank you everyone for your guidance

I decided to wait on the fuel injector coming from an online source. There are many vendors selling them for between 40-60$. I just can’t justify installing the one I got from the dealer which was close to 380$ after taxes. Dealer told me I could return it if it isn’t installed. So I’m hold...

I did change the fuel filter after I got everything put back together and before I started it. It idles fine with the exception of the knock. This was an expensive lesson not to touch the damn injectors. Should have been a 15$ fix. The only reason I messed with them in the first place is the...

So I loosened the fuel line to fuel injector number one which happened to be the one right behind the fuel tank. Immediately the knocking went away. I loosened the fuel line to fuel injector number two and tightened the fuel line to injector number one. The knocking came back. So I know I have...

The knocking went away then came back. I took a vid but not sure how to post it. Maybe one piston wasn’t getting fuel so it was dry? When I rev the engine it gets worse. It idles now and every 5 seconds or so there is a slight knock or knock, knock.

Well I got everything back together. Replaced the fuel filter. Disconnected the fuel line just before the filter and have fuel flowing. Disconnected fuel line before the injector pump and have fuel flowing. Took a while to start probably due to air in the lines. According to the manual you bleed...

I was quoted $350 a piece for new injectors. So that’s a bit more than I want to spend right now if I can avoid it. I will definitely try all of those cheaper suggestions listed above. I did snap that return line around the injectors, so I’m driving to get that part now. And I will probably...

I did run it with the fuel cap off thinking there may have ben a vent issue. It didn’t seem to help

I wound up taking the fuel filter out and swished it around in a clean jar of diesel then blew air on it. Only because I didn’t have a clean one on hand. There were some larger particles of debris on the outside of the filter and a few small pieces of dirt resting in the bottom of the filter...