Recent content by vern748

TK. Might have to find me a little piece of plastic and make one.

On the Branson 2505 there is a 1x1 square just above the hazard flashers on the left side of the dash. Its likely used for an aux light switch location or something ( that's what I'm using it for) . The cover on it is rubber and not likely a good thing to mount a switch to. Looking for a hard...

Very recently ( 8hr on it now) got a 2505H Branson with a FEL and BH. Love this little tractor. Great size and does everything well...for what I need. It came in handy a few day after I got it. My other tractors do not have a BH, and I would have been so screwed. The power to my well house went...

It says 224.

Please move if need be.

Looking to sell my YM155D. This is a great tractor, but the size is just too small for what I need. Upgraded to something a bit bigger and a bit stronger. Come with a FEL and rear box blade. It has rear wheel weights. Here is the new stuff: Clutch - 2018 Driver seat - 2018 Fuel filter, oil...

Hi all, Just to get correct information out there if anyone comes across this on the YM155d. The fuel injector pump bleeder is above the level of the fuel tank. You MUST have 4+in of fuel in the tank for it the bleed correctly. Thanks everyone for your assistance..

HI, Thanks for the assistance, but I know all this, and have looked through the Hoye tractor instructions. I think we are not seeing the salient point here. The fuel bowl is below the fuel pump, unlike most every other tractor, tank, car, generator, etc, I have ever worked on, including my...

Hi All, Before you say so, I know, stupid me. Ugh So, it is a YM155d. I know how to bleed a diesel fuel system, but this one has me stumped. The fuel bowl is below the fuel pump !!?? I bleed the bowl. I bleed the left screw at the bowl I bleed the right screw at the bowl I go to bleed the...

Hi All, My kt735 appears to have "lost" its compression release. It will spin up fine on the first attempt to start. If it does not start on this first attempt, its a pain to get it going. For some reason, it becomes difficult to turn the crank. The battery is fresh. If I attempt to jump from...

I was able to get out the stub axle with a bit of tinkering. The bearings are pretty tight but do come out. There is a problem reinserting the axle back, since the ring gear drops and is still within the knuckle. Will either need to remove the knuckle or the entire unit. Not a pretty picture...

Hi All, Looking for advice on removing the turn signal switch for my 155d. Standard black switch, center, left, right. How do I remove the leaver ? I see that the headlight switch has a set nut. Don't see one on the turn signals. :confused:

I can get a complete brand new loader, everything, for my YM2000 from coldwater tractor for $1800. This is all they are making, just 1ft longer and wider using 3/8 iron. Car keys used for scale

Hi, I have a YM2000 compact tractor, 14hp, I think. I have a FEL but it did not come with a sub frame for the FEL. I went to a welding shop and had them price it out for me. Its a pretty small. Main support is 6in L on 3/8" steel. The rear support is 3in wide, running 3ft to the rear. The...