I have a well used Kubota GS200 fire pump and I have been trying to lookup parts and not having much luck.
The manuals all seem to require $$
It is not worth spending much on and is using oil so just wanted to try and get some idea on parts.
I have been letting it sit with the head off with a...
Well it is Chinese! The bevel is on the top when back dragging.
You can see in the first pic the angle I need for the cutting edge to actually touch the ground.
I am thinking about adding teeth so may be able to change the bevel location to the top.
Need to do some drainage work with my little tractor.
How sharp should the cutting edge be on the bucket?
I guess the sharper the better? Mine has a few mm radius.
What is a bit confusing is all pics I see on google the bevel is on the top with the bucket opened up used as a bulldozer blade...
I bought a used Regent fire pump made in Australia and it has a Kubota GS200 engine.
Seems to be working well after a little tlc but the seal is leaking behind the pump.
I have the front removed and can't get the impeller off.
It has no bolt in the front and I am guessing it is held on by a...
My MS171 has been getting treated pretty bad lately to make up for the time it spent broken.
Ages ago I changed the bar from .043'' to .050'' to allow decent chain.
I always run chisel chain on my saws but the only one available was genuine Stihl.
When I made an order for some stuff I bought 3...
I have made a leveling bar for my tractor and it works not too bad off the 4 in 1 bucket.
But I also added chains so I can tow with ride on.
On flat gravel or sand it works great but as soon as I hit bumps it bounces as it is too light.
So I added some wood as weight and it is better till you...
Hi I have an Eastwind DF254 which is very similar to the Dongfeng 254. I am not sure if my bucket is curling back far enough. It hits the limit of the cylinder travel.
I would have thought it should go back further than it does. Can the linkages be assembled incorrectly? Guess I need to take a...
HI I have an MS171 that I opened up the muffler on. It starts and idles fine. Low end seems fine.
One day it screams and cuts quite well. Next day the top end is off and you can hear it is not right.
Only takes a slight adjustment to get it singing again.
But I just leave it as is and use it...
Hey everyone I only just found this forum and wanted to make my first post. I have hopefully found my fault but wish to run it past everyone.
I have a Chinese Eastwind tractor with FEL. Just the other day I noticed when I curl the bucket back just feathering the lever the bucket dumps.
If I...