Recent content by TRACNUN

thanks, i had those resources as well, i finally went 60 foot lbs, hope that will be ok, one post somewhere said 150 and i was like lol no way

not one reply

Age of thread is irrelevant, the next person seeking info is getting more info than was here, thats the value added proposition of forums

ulsd is only for autos and over the road, can still be in off road or heating oil if that is being used. "on-road" (15 ppm) and the "off-road" (500 ppm) diesel fuel i find it hard to believe you would smell the battery in the open air, but whatever I had a car that did this, smell was so faint...

I've got experience with this problem, go for fuel or oil. ------------------------ I was driving behind a camry and the exhaust fuming coming out were so strong and stinky. There were no other cars. I had the AC in my Prius on recirculate. Why would a Camry be so stinky? It could be possible...

hydrogen sulfide can be in the fuel or oil, you can have two vehicles both same oil and fuel and one can smell and one wont do to a number of reasons. most likely wont smell when cold too rich when hot can contribute, will probably smell when throttled back to idle

My boomer 40 was tooling along one day and their was a little bang and I swore I saw a front tire lock for a second, I stopped, then started and it was ok. A few months later I was loading stuff and it went bang again and locked up, I unloaded the bucket put it in 2wd and it was still locked, I...

I have a manual SERVICE MANUAL Boomer ™ 40 Boomer ™ 50 Tier 3 Compact Tractor and nowhere does it show the engine flywheel or its 4 bolts, so no torque values either. also, in the bell housing, the drive shaft cover that has three bolts, you have to remove to replace the seal and o ring, it...

My cost using a hy cap clutch and bearing is under 700 for clutch disc, plate, machining of flywheel and chemical sealants.

I am installing the hy cap clutch right now, we got a lot of use from the factory clutch under extreme use, so we are a good candidate to see if they are hi quality replacements, I got mine from Larsen lights as they had the best price, and confirmed prior to sale they were in stock no delay...

i agree, I had the same type of grooving, we have a loader and use it like a bulldozer, have moved almost 1/4 mile or boulders building a road 3 feet tall and 12 feet wide, as well as other similar projects, and my mom rides the pedal, I saw this same grooving on the pressure plate side, no...