Recent content by toukow

Sorry, can't help you with your problem. I did want to mention that if you have any interest in the full electrical schematics for the RX6020/6620/7320/7620 series, then PM me. They are 2 paper sheets 18"x36". I posted previously asking if anyone owned one and got no response. Toukow

Sorry for my confusion.....

From time to time, my tractor has been having issues of reaching rated PTO RPM, which I’ll post about separately. While looking into this, I found errors in the Kioti CK2610/3510/4010 owner’s manual. My owner’s manual is dated JUL 2018, so perhaps this has been corrected in later versions. My...

I’ve never seen anyone post on making the connection you reference to the instrument panel brake light symbol. Someone did post where they had installed a limit switch for the parking brake lever, which seems like the correct way to go. I was going to go down the limit switch path, but then...

Anybody own one of these tractors on the forum? Thanks, Toukow

Probably not related, buy I had tachometer totally weird out on mine with around 120 hours. I did not look at any other dashboard indications during this event. It was running and I looked at tach as I was running a brush hog, and it was pegged off the numbers on the high side of 4000 RPM. I...

I wrote a question about this too for my CK2610. I had read elsewhere that your approach is correct- don't screw in threaded dipsticks, press in the ones with O-ring type seals. So I filled to the mark without screwing it in. I was glad I followed another poster's advice which was to check the...

Did the manual come with a separate envelope that contained complete wiring schematics? I am simply trying to verify what came with your purchase. Thanks!

This is a known problem. A couple of solutions are proposed in this thread. Restrictor by Michigan Iron, and a flow valve by Stan B. on page 4. I'll probably use the latter. Toukow https://www.tractorbynet.com/forums/threads/kioti-ck3510-loader-issue.414976/page-4

Yeah, if I had them, I wouldn't be asking about them. Guess I'm one of the few who buy paper factory service manuals......

...... a separate envelope containing large, folded, complete wiring schematics similar to photo? Thanks, Toukow

I have the same tractor with 105 hours, so just ran an experiment (friggin’ engineers, don’t ya know!) timing the oil light using a stop watch. I have: no block heater Rotella 15W40 T4 conventional oil 55 F ambient and stable in shop last start 6 days ago time for oil light to go out after...

adfd Thanks for the education. I had always had taken the passing comments that the 3510 and 2610 were the same tractor, except engine size. I guess there are other differences as well. If my list of 'to do's' gets too low, I'll consider trying to fabricate something for mine. Thanks, Toukow

unclesalty-Can you post a picture of the mounting location of the step you have on the right side of your CK2610? I’m confused on this. My dealer said (as of yesterday) there is no right-hand step available, and claimed to have discussed with the Kioti Rep. Here’s a picture of my right-side...

As far as I know, the 3510HST is the same as my 2610HST in this regard. As sea2summit points out, the owners manual on page 7-21 lists 5, tractor only grease points to be done at 50 hour intervals. I'm inferring that the PTO lever you reference is actually the three point lifting lever...