The glow plug circuit is marked in yellow, the glow plug timer circuit is in blue and the circuit to the indicator lamp is in yellow.
The glow plug timer ONLY controls the glow plug indicator light on the dash board and the glow plugs are hard wired to the glow plug connection on the ignition...
I just looked at this procedure in the service manual for my TC29D since it is nearing the 600 hour mark. If the valve cover isn't hard to get off it looks like a straightforward job. I am also not sure what the access is like to turn the engine over by hand. You'll need a good feeler gauge...
I ordered a NH 84475483 hydraulic filter from Messicks for my 2001 TC29D. This is supposed to be the replacement for the original number 87300043. Today it arrived and although it looks like the same exterior size, both the box and the filter itself are labeled "Fuel Filter". I tried...
With inspiration and thanks to Sodo
http://www.tractorbynet.com/forums/build-yourself/321435-50-inch-brush-fork-build.html
I built a set of brush forks for my New Holland TC29D:
The material is all 2"x 2" x 3/16" square steel tube. I purchased 36' feet of material and used almost all of it...
That looks pretty slick. I think I will just stick to something simple like drilling two holes in each of the outside forks and through the bucket, then using pins to hold the forks in place. I may need to weld reinforcement plates on the side of the bucket.
I did a test fit last night in...
My TC29D has a "flaky" ignition switch. By that I mean you have to get turn and push it just right to get it to start. In researching the problem I find that this is not uncommon.
http://www.tractorbynet.com/forums/new-holland-owning-operating/163355-tc29d-ignition-switch-replacement.html...
Last week I sold my 46" garden tractor with the intent of getting a zero turn mower. I've been looking around a bit this week and talked to a Hustler dealer today who really turned me off on the bagger. He said he has NEVER sold a bagger. I know there are other brands that advertise and...
I have a NH TC29D with the heavy duty bucket which has a round reinforcing bar across the top of the bucket, like the one in this picture (picture is not my tractor). I need to mount some chain hooks on the bucket and am wondering what the best way to deal with the round surface is.
The...
Yesterday I went shopping for my first tractor. I think I am looking for about 30-35 HP, 4WD, with a loader. The use is mainly for dirt and tree work. My property is mostly wooded with elevation changes. I need to tame a lot of it. Mowing is not a consideration. I am not sure about...