Tinhack's latest activity

To this, I say Baloney! I have two flail mowers and they both cut grass and brush as good or better than any finish mower. They both...

Wix was bought out by a German company--MANN+HUMMEL. I've seen a reduction in Wix filters over the last year or so although MH claims...

The same goes for Saki. :sick:

“Yes, vermouth can go bad. While it has a longer shelf life than regular wine due to its higher alcohol content, once opened, it should...

A Rubbermaid 50 gallon stock tank to use as a vanishing fountain reservoir for my giant clamshell water feature.

Last week I installed these powder coated screen guards (6" x 3' lengths) on our 40' X 30' detached garage; about 85 linear ft with a...

That picture might as well be in braille. And it's chopped off. See if the starter spins if you jump the purple(?) and red(?) wire. MAKE...

There might be two set screws located 90 degrees apart. I would fully remove all the set screws and fill the hole with penetrating oil...

Allen Screw Deep inside the hole shown would be a common method. If it’s never been off a good penetrating oil applied ahead of time...

There may also be two set screws stacked on top of one another. That was a common way to lock shafts and keep the set screw(s) from...

I only remember one of Bobby Sherman's songs. I was already out of high school and caught up in the Beatles and Rolling Stone's music.

https://www.yourcentralvalley.com/entertainment-news/ap-bobby-sherman-teen-idol-in-the-1960s-and-70s-and-later-a-cpr-teacher-dies-at-81/

Unless that's a tiny girls hand in the picture, they look like 1/4" NPSM Female fittings on 1/4" hose. ;) I have those. You can get them...

Looks like a female pipe swivel (NPSM). You need to look at a table of sizes and get out your caliper and thread gauge to see what size...

Well, I may have to get my '56 420C running again. I hate the thought of installing parts in the rear end though. It needs steering...