Tinhack's latest activity
-
Tinhack reacted to bmaverick's post in the thread I need help finding Yanmar 1600 parts. Valve cover and exaust with
Good Post.
I believe it's called the engine head. It's a major part. About $2,000 in prices today vs. 3 years ago being $900. The YTOG has the... -
Tinhack replied to the thread open hydraulics.That's why you only read 30-40psi. The P port is the pressure Input to the valve. Teeing on that port will only have "Return" pressure...
-
At this point no one knows WHAT'S possible because no one knows what you have. Is this a dedicated loader valve that has the problem...
-
Tinhack replied to the thread Harbor Freight Tools that don't suck.They used to be. I have one of their bit stands from the 60s somewhere. I could never afford them. That would be one way to tell. If you...
-
Tinhack replied to the thread open hydraulics.30-40 psi is typically a return to tank pressure. You're not teed off the correct line or you're teed on the down-stream or open center...
-
Tinhack replied to the thread Harbor Freight Tools that don't suck.Well, I know you haven't bought any drills bits in over 30 years then. Cleveland Twist and Chicago Latrobe were bought out in 1995 by...
-
Tinhack replied to the thread Harbor Freight Tools that don't suck.I've done that many times and as you say, the results can be inconsistent. Many times the price will go up. I just delete it from my...
-
Tinhack reacted to Oaktree's post in the thread Harbor Freight Tools that don't suck with Good Post.
I've heard of using that trick with Amazon. I tried it a couple times with inconsistent results.
-
Tinhack replied to the thread Suggestions for a post hole digger?.A grapple was the first to come to my mind. Or a hay bail clamp, two way bucket or angle plow. I'm sure there's more. I don't know what...
-
Tinhack reacted to JCoastie's post in the thread Suggestions for a post hole digger? with Good Post.
I've never seen a square one, but they make adapters. I use a hex to round adapter on mine, adds a little extra depth too, works great...
-
Tinhack replied to the thread 3 point hitch will not lower..If your tractor has draft control, that being on can also slow movement of the 3Ph. But yeah, that turtle can cause problems sometimes...
-
Well, I learned something from you folks. Now I know what that little knob that has a picture of a turtle and bunny is for! I did have...
-
Tinhack replied to the thread how much gear oil for a woods RC-5 rotary cutter?.In my new (last year) flail mower, I used 75/140 full synthetic. It came in a "bag" with a spout that was easy to install. It took one...
-
Tinhack replied to the thread Gas Shutoff's.That's a common misconception. Ethanol itself does not gum up anything. In fact, it's a cleaner for fuel systems. Most all fuel system...
-
Tinhack replied to the thread No spill nozzles.I bought new pour spouts for all my new gas and diesel jugs. Drilled a 1/2" hole in the jugs and added the vent in all of them too...