Recent content by selkplitt

The cup and washers under the blade could have worn some from the spinning blade. They are probable the reason you have to torque it down so hard. I replaced the cups and washers on all spindles and didn’t have a problem again after that.

I have a wagon from www.countrymfg.com A wagon is nice because you can keep it loaded and there is no tongue weight. However you can’t back them up. i put firewood in it and bring it down to house and leave it there. When empty just repeat. A trailer is better for backing but will have tongue...

my 2230 with 410 hours won't raise all the way and then release the lever. I have to move the lever to raise about 3 times before it is all the way up. Sometimes the lever will not return to nuetral either. Any help is appreciated. thanks

on my 2230 with 410 hours, the 3 point will not go up and release lever automatically. it goes about 1/2 way up and then stops but won't release the lever. Then I move the lever and again and it goes up more, but not all the way, finally, if i hold the lever, it will make it all the way up. the...

does anyone have a fix for this? when lifting the mmm, it raises uneven, it seems as though when it gets to the mowing height it levels out but when raising the one side lift about an inch to 2 inches before the other side raises. I have checked the lift linkage and there seems to be play. Is...

Has anyone put these on the back of a bx 2230 or the like. I am curious as to how it hooks up, do I have to have the deck off to install the suframe and can I leave the subframe on and put the deck on? I have 150 hours on my 2230 and I don't know whether to go with a bx24 or get the aftermarket...