Recent content by Seabeckredneck

Thanks for the feedback and information. I just logged on with a different laptop and I don't have the pop ups! So now I know which computer to use. I'm sure you can understand my frustration but that is no more. Thank you

While I enjoy the forum, I just can stand all the pop ups. After reading a couple posts, and wanting to read more, I get tired of all the distracting pop ups. I check back a few months later only to find it's still a forum of ads with an occasional post about tractors... Whoever is running...

Something that big, I use Star torque. Using a 3/4 or 1 inch drive rachet or breaker bar, get in a proper postition and just puuullllll until you see stars! That should be tight enough. PS make sure you have something soft to land on incase the lights go out...

G'morning Gents, I have a JD4320 with a 448 backhoe. I've been digging a drainage ditch and hit hardpan just a foot below the surface. I've been slowly scraping away at the hardpan so it is taking a long time. Ok, I just assume it doesn't have the power or the weight to penetrate the hardpan...

I've searched the forum but haven't seen anyone with this issue. I have a 2011 4320 and I recently purchased a frame mounted 448 backhoe. I took off the 3 point arms and installed the brackets which stay on the tractor to which the backhoe attaches. Well, I've taken off the backhoe for the first...

I've used this site many times looking for information for my 1948 Ford 8N and now I also have a new John Deere 4320 with a 400X loader which I use on 6 acres. I recently found a 448 backhoe that is in great shape and put it on the 4320. Now I'm finding that the 3 point doesn't lift high enough...