Thank you again JC-yes the area is spotless around the valve cover area which i cleaned when I put gasket sealer in place of the original gasket which was smashed-i noticed t other day after driving it-oil or gas around the bottom of the injectors-i tried to tighten them but they seem snug...
Thank you again JC-where’s the best place to get injectors for my 1210-i made a valve cover gasket for it but it looks like it’s seeping fuel or oil around the injectors-it’s kinda bothersome because it’s a clean tractor and I’m trying to keep it that way
Yea good idea-I’ve got a question about fuel injectors-is there a seal or washer that goes on the injectors between the injectors and the engine block-kinda like a spark plug has
Hey JC -i did replace that original fuel bowl with a aftermarket wix type ( car fuel filter) it works fine-but did have to bleed the air out only twice to get the tractor running-thank you for your knowledge 👍
It’s a o ring type-i removed it and cleaned up the cover-then put atv blue in place of the o ring gasket-it’s on the tractor I’m giving it 24 hrs to dry before starting-I’ll keep you posted-thank you again for your advice 👍
Hey JC I’ve got the valve cover gasket out and cleaned up-do i leave the old O ring gasket in place and silicone over it or remove it then silicone the cover-thank you again
Oh wow-thank you again for your advice-i normally buy from Amazon-filters ect-I’m kinda new messing around with these older tractors-i was into the trucks and cars for years-kinda changing hobbies 👍
Thank you again JC-i do not have any pic’s right now but mine looks similar to yours-where did you purchase that from-I’d like to keep it original as possible-vs-rigging