Recent content by rockyroadnz

  1. R

    B7100 HST input shaft stripped spline

    Hello ABBIY. my only thought is maybe you have missed/dropped the key that goes in the keyway to drive the charge pump. I referred to it in step 4 on my lengthy post on May 19, 2018
  2. R

    B7100 HST input shaft stripped spline

    Hi, sorry - missed your earlier post. Here's the invoice for the bits I got. The suppliers contact details are on there. Good luck
  3. R

    B7100 HST input shaft stripped spline

    Hi again ToastySteve. One more thought (and sorry if this sounds silly) - did you remove the second circlip I mentioned in step 1 of the shaft replacement instructions? It is number 20 highlighted in this pic
  4. R

    B7100 HST input shaft stripped spline

    Apologies for long post. I have replaced the HST input shaft with the stripped spline so I thought I'd give an update on things I learned along the way in case the information is useful to anyone else. I've split the tractor, removed the HST, replaced the input shaft, bearing and seals plus a...
  5. R

    B7100 HST input shaft stripped spline

    Hi, my Kubota B7100 HST lost all drive and I found that the input shaft to the HST has a stripped spline where the driveshaft from the motor connects to it. That kind of ruined my day. Can anyone tell me: 1/ if it is possible to remove the input shaft from the HST? i.e. can a person with good...
  6. R

    Tipping / dump trailer. Will this hydraulic ram work?

    Thanks Redman your last comment was extremely helpful. Hello forum readers. It痴 been a long time coming but I finally finished my 3.5 ton tipping trailer and also built a petrol powered power pack for it. The majority of it was built with things I 壮crounged for nothing, but regardless of this...
  7. R

    Tipping / dump trailer. Will this hydraulic ram work?

    Thanks everyone for your comments. Very helpful. It’s a good thing I asked before I started mounting the hydraulic ram. Regarding Redmans post. Thanks - I had not thought of putting the ram 'laid forward' so I have redrawn it that way in a scale drawing and with a 55 degree tipping angle. The...
  8. R

    Tipping / dump trailer. Will this hydraulic ram work?

    Tipping / dump trailer. Will this hydraulic ram set up work? Hi, I am building a tipping trailer to use behind my tractor, using some recycled parts to minimise cost. I have got the trailer and tipping deck built but before building too much steel work for the ram I wonder if anyone can tell me...
  9. R

    Correct track size for Yanmar B22 excavator?

    Hi, I need to buy new rubber tracks for my Yanmar B22 excavator, but I am getting conflicting information about the correct size. Can anyone tell me what size tracks are on their B22? My old tracks are not Yanmar original equipment. They are Avon brand and they do not have a size marked on...
Top