Roadworthy's latest activity

I'd stop by an LS dealership for more information. LS tractors were sold as New Holland among others but you'd have to know which model...

If you're looking for a tiller a five foot would be a piece of cake and a six foot should present no problem.

If the tractor is new it is indeed a dealer problem. If you bought it used it gets more complicated. I'd start by replacing the...

Have you managed to remove the old starter? Is the new one identical? Does your wrench not fit the bolts? See the above post by...

Take it to a vehicle drive line repair shop. I don't mean Auto Zone I mean a place that can actually repair or build a drive line...

You may save yourself some grief taking it to a local hydraulic shop. They will in all likelihood be less expensive than Kubota and...

I have your typical Pequea 10,000lb 20’ trailer. It’s a 2022, so still fairly new. Been a very good trailer. Typical uses are hauling...

I know nothing about the model other than a loader was an option. You may be able to locate one at a tractor wrecking yard for that...

Look the wiring itself over carefully. Mice may chew or eat the insulation off the wires allowing them to short to ground in hard to...

You could also consider having the trusses professionally built and collecting the rest of the parts as required. That's how most of...

How did you check the battery? Monitor the voltage as somebody tries to crank the tractor. If it drops below say ten volts it's time...

Are you getting any error messages?

In essence I'm saying shoot for the middle. That gives some latitude either way. It's not really an exact measurement.

That's one inch plus or minus two tenths of an inch. I'd shoot for one inch and tweak if needed.

The B and the L series are frame sizes. The numbers are related to horsepower. Tractor Data is a big help. Avoid older "gray market"...