Roadworthy's latest activity

I don't think Independence Day was belated - perhaps the greeting is. It was typically loud, illegal, and the dog went regularly...

The hydraulic pump on many tractors is geared off the crankshaft at the front of the engine. If the seal leaks it can permit hydraulic...

Do you lose water due to a leak or evaporation? Try to give a little more information.

Did you change the filter or just the oil? Try replacing the oil pressure sensor with a gauge temporarily.

Do you need the complete shaft? If the ends are intact you can buy just the shaft material (inner and outer), assemble into the ends...

I had that problem with my car. A box of D-Con behind each headlight gave them something to eat besides insulation. Mice gotta eat...

Make sure the air filter is clean and the air path is clear. HOW did you verify the glow plugs are working correctly? Did you verify...

The oil capacity given in the specs is for a new engine. All the oil never drains our unless the engine is disassembled. Go by the...

Transmission and hydraulic go longer because there's no combustion in those places.

You could begin by finding out if you even NEED to register your tractor for the road. In many states it's not required or even...

This morning I made a modification to our tractor so I can control the throttle from the backhoe operating position.

I don't know your steps for engaging the PTO. I leave my tractor at idle and depress the clutch. I then engage the PTO. I let off the...

I don't know Toro model numbers. Mine has a belt to drive the blade and another to propel the unit. The belt to propel the unit is...

It could be a typo or a misprint. My Kubota manual specified 50 hours.

How is the lever attached? The bolt on which it pivots may be too tight or it may want a little grease. Is something binding there...