ray66v's latest activity

Yes, ideally it's in the center of the sight glass. However, after owning one of these since they first made them, the oil level in the...

Yes, it's fine.

I believe a lot of us are currently using Rotella T6, 15w-40. Hard to beat. A quality product for a good price.

Well, I'm getting better at this... After using the FEL and BH to handle firewood logs, I --once again-- went through the conversion...

Sam, sorry you are being frustrated by your tractor. I suggest you start a thread, with your original post. There is a better chance...

But, but, if it meets the spec's, it just as good. 🤔 Tractors, and repairs are costly. I don't think hydraulic transmission oil, is a...

I don't know about Canada, but here in the US, it gets dark by as early as 5:00 pm in the winter. And the sun doesn't rise until as late...

After installing more aftermarket body parts than you can imagine, I have a very low opinion of them. ESPECIALLY lights. So, while...

MF parts are commonly as much as 3x higher than a similar automotive part. But, in the case of that headlight, it's actually not out...

The newer standard is to make hydraulic oils multi-viscosity, rather than the straight 30w it was years ago. This helps with operations...

https://www.303tractorhydraulicfluidsettlement.com/ The above is for the "But, if it meets the spec's it's good" crowd.

Harbor Freight's 3/8" couplers, needed for the 1/2" drive Earthquake impact wrench. 1/4" brass couplers were literally strangling the tool.

Thanks guys, I updated my original post to reflect that they fit the 2300 series. I can't speak for the 2400 series. Someone else will...

yeah 17x series is different than 23x/24x, and I may be wrong but think the 1723/1725 may be different than 1700/05/10/15. don't have...

Interesting, looks like MF changed the lines on the later GC1710. Mines 3/8 npt. I know this coz I also bought one of these things...