Greetings All!
My 4600 temp gauge finally bit the dust - was acting erratically for some time but now the needle is pegged to the red zone and won't move (even when the tractor is off). I have seen a few posts here on this and would just like to replace the gauge and not the whole console...
Greetings All!
I did a search on this but did not recover many threads. I'm often out working in the pastures and could use my saw only for a quick cut - - naturally I never seem to have it with me when I need it. That said - if someone has some ideas with pictures to share that would be...
My 4600 has had an issue off/on with a loud "grinding" sound sometimes when I turn the key on. After one or two attempts the started will engage and turn the flywheel over and start. The problem is getting worse. Anyone else have a similar issue? Is it likely a damaged "bendix" type gear on...
Greetings All!
My 4600 refused to start today - cranks fine but no start. Of note, I do not hear the normal "click" when I turn on the key. I had problems with the thermistor in the past and replaced it - it solved past cold weather problems. I shorted the wires leading to the thermistor...
Sometime ago I was having issues with the HST gear range switching - even on level ground it was very difficult to go from low (A position) to high (C position). I left it in "A" since that's what I mostly use. After a recent service I accidentally moved it out of the "A" position and now it...
Greetings All!
Considering the purchase of a sickle bar mower for my JD4600. Will be using it to clear around roadways and pond areas with steep grades. Considering a 51/2 foot unit with a hydraulic lift. What additional hydraulic "stuff" do I need to operate there units - my tractor has rear...
Greetings All!
Considering the purchase of a sickle bar mower for my JD4600. Will be using it to clear around roadways and pond areas with steep grades. Considering a 51/2 foot unit with a hydraulic lift. What additional hydraulic "stuff" do I need to operate there units - my tractor has rear...
Got a similar problem with my 4600 (~1200 hrs) - no start but cranks fine. Suspected the thermistor based on the comments here. It was a real PITA to access - used the suggestions in this and other threads. Removed the fuse box and was barely able to get access (very tight wire harness) -...
Split a lot of wood with this beast for over 20 years.
Last year started to have intermittent problems with splitting and return speed - I replaced the 11GPM 2 stage Haldex pump with original from Northern - - seem to have fixed the problem until now.
Now, I get significant amount of "air" in...
Got an old NH 20T log splitter - ~25yrs old. 5HP, 2stage 11GPM pump, 4"x24" ram.
Worked fine for 25 yrs - recently noticed some decrease in splitting power. Now, it will pause when it meets a log, then after a few seconds a massive "POP" and it splits the log. This is in contrast to the usual...
Greetings all!
Got a 4600 HST w/ ~1000hrs. Over the past 4-5 months it was difficult to get into the lowest ("A") forward gear - but with gentle rocking of the pedals it would engage. Now, no matter what I do I can't seem to get it to go into this lowest forward gear - - no problems with mid...
Hi All -
New guy here -great forum and would appreciate some advice.
Got a JD 4600 w/ 460 loader.
Found a used 48 hoe w/18" bucket I'm considering. It is real dirty but looks in "good" condition, needs seat and other small items. Owner say's it has about 50 hours on it. Hoses have been...