My father in law has a 08 ck20s with the 120 loader and kioti 60 inch rear finish mower. The tractor has 366 hours and is garage kept. Blow the dust off it and it looks like new. The RFM was used a few times a year until this year when I used it weekly to cut my grass. It was used to help take...
Walked out to the garage to hook up the tiller on my 2004 Ck20HST and immediately noticed a large pool of oil under the right front tire. Looks like the seal went out on the pivot joint, where the wheel turns, and the left side is wet around the seal but not dripping oil like the right. The site...
The gear box pulley on the MMM will not stay in place more than 3-4 mowings. It slides down the shaft. When it happened again about 6 weeks ago I replaced the Allen head key screw with a small square head screw so I can really torque it down. I thought no way that is moving. I even took a...
I am building a pergola over the deck and have used pressure treated for everything. This is an on going project I started last year with putting in the support posts and main support beams. I am staining the entire thing with an opaque stain from Sherwin Williams. I have used both the...
Okay, what's the trick to getting the FEL off a CK20. I followed the manual to no avail. Slowly ran the bucket and arms through every angle to take the weight off the pins, but they aren't budging. Sighhhhhhhhhhhhhh, what's the trick?
A little incident happened, let me set it up. I have 15.5 hrs on my CK20HST I mowed with it intially the first two days after I received it knocking down the weeds around the place. I am working on planting grass. About two hrs total time using the MMM. I took the deck off about 3 weeks ago...
Does anyone else have a MMM. After reading my manual I should be able to lock my MMM in the up postion with a lock bar and be able use the 3 pt hitch without the MMM going up/down. The manual says the bar maybe installed "if desired", I take that as if you want to lock the MMM up. The picture...
Recieved my 20 HST today woohoo. I put about an 1.5 hr on it and just as I was finishing mowing I see the MM deck is shing/glistening with a liquid. I am thinking " oh !#$!# a hydraulic leak all ready" Well it is coming out around the compression fitting going into manifold for the bucket...
Prospective buyers in the Northeast check the classifieds at the top of the page. There is CK20 HST with loader and rear blade and turf tires that has only 6 hrs on it for $12,700. Located in CT.