Recent content by oliveiracarlos

Thank you all for your support. @Sawyer Rob the plug was were you mentioned, it was hidden by some oil. Here is the place for future help.

Thanks for the help, Is this plug next to the gears shift?

Hello all, Until now, I only found a screw under protection covers next to the shift levels, but no oil dipstick. Does anyone know where to find the oil level for this tractor?

Hello all, Thanks for the help and support. I haven't found any dipstick or oil check screws. I will ask in the Facebook groups recommended. I've tried to get the service manual, but the one I have does not mention it. Best regards, Carlos Oliveira

Hello, Thanks for the support. There is no dipstick and in the rear of the transmission case there's on window. I guess one of the screws, when removed, shows us the limit.

Anyone can help me?

Hello, Only now did remember that e forgot to send this picture. Hope that I will still be on time. Thanks and sorry

Hello all, I have a Lamborghini 550DT tractor and need to add some oil to the hydraulics/brakes, can any one help me find how to check the maximun oil limit? Thanks for the help, Best regards, Carlos Oliveira

Hello, Thanks for the answer, in my tractor has a single pump only that works both for steering, PTO, lift and the two aux outputs.

Hello all, My Lamborghini 550DT has a front loader and it´s hydraulics are connected to the rear hydraulic output. I have been told that it should be better to connect it to the main hydraulic line, but I don´t know if it´s possible and how to do it. Can any one help me with this issue...

In the beginning I was able to stop it by hand, but now it´s more difficult. When I hook the bushhog, the chains below start to rotate without turnning the PTO on on the lever.

Hello, Thanks for you help :) I was expecting that it would be easier :) Best regards, Carlos

Hello, I have a FORD 3910 and have a problem with the PTO problem that need to solve. - The PTO does not stop completely and is always turning, I know that there´s a break that needs to be changed, but I don´t find where it´s located. Thanks you all for your attention, Best regards, Carlos...

Hello all, I need your help with my Ford 3910, the hydraulic from steering is leaking oil, see images in attached. Can anyone help me figure how to disassemble it to change the sealants? Best regards, Carlos Oliveira

Hello all, My hydraulics don't go down. Has anybody already got this problem? Thanks for the help. Regards :-)