oldnslo's latest activity

Mark, How many hoses or lines connect to your loader valve? 6 or 7? Does your tractor have 3 point hitch? I can’t tell for sure on the...

No you cannot draw oil through the pump and couplers on you tractor.

It depends on control valve features. If the tilt has anti- cavitational check valves or work port relief with anti-cav feature it could...

Deere dealership

My neighbor is a semi retired horse trainer and he said a good new saddle for pole bending or barrel racing is over $2000 and...

Since these have been stored for ten years is there any concern for dry rot in the leather or stitching?

Follow the hoses from the lift cylinders back to the quick disconnects. These will plug into the two connections in line with a spool on...

That is an absolute last resort😁 7 degrees you should be OK. To sharp of an angle and you may get some vibration or chatter from the...

I think you need to support the weight of the machine under the flywheel and not the infeed hopper. Like runner states: Running the PTO...

IMHO it is best to run any PTO equipment keeping the drive shaft at level as possible to save wear and tear on the U joints. I place...

Does your RD522 valve have the power beyond feature installed and operable? If yes then power beyond from factory valve connects to...

Do you have factory service manual? Wondering if some how forward and reverse was not set correctly from factory since normally travel...

Did the rod break or come loose at crank end? Could have been faulty rod end cap or rod itself. Not common but it does happen. Either...

Do I see a “tee” fitting in both of the lines to the new valve? I belief MF1528 has fixed displacement pump so all valves must be...

EPDM is more weather resistant that nitrile and repels water better but depending on type of EPDM compound it may or may not be...