oldnslo's latest activity

What size holes are the entry and exit? 2” diameter 4”, etc. Around here wood chucks love to dig under buildings but they leave a big...

Is the ground to left to soft for backhoe to lift the left rear up out of the muck? Presume yes but hard to tell from picture.

Glad you have it figured out and agree there are way to many fitting options these days. Hopefully you are not like me where learn...

Try swapping the lines from raise - lower to curl dump to see if either function will now operate.

Just to let anyone know in the future, it wasnt the pressure regulator, and it wasnt the charge valve next to the filter. It was the...

Sounds like there is blockage in the passage between the filter and charge relief. Have you tried blowing air from the charge relief...

Will it float in either direction? I.e. push in but not pull out? Just asking since a partially seated quick disconnect or a failing...

Does the oil look foamy or is it pretty much clear oil? Did you recently remount the fel or any other changes to hydraulic circuit...

Does the drive shaft slide apart? If yes have you confirmed the phase angle of U-joints is correct? Most shafts only fit together one...

I believe that is a pipe swivel end on the hose. Mating fitting must have taper to seal on mating taper in the hose end. Suggest try...

Have you checked to confirm the power to the 3rd function is 12 VDC when command is active and 0 VDC with no command? Don’t remember...

If sudden then need to find what passage or flow path is plugged from the filter into the hydrostatic curcuit. I believe the filter...

Parker, Imperial Eastman both used to make good flaring tools. Not sure about today though. Other option is to purchase the ferrels for...

I am not familiar with liberty hoe but from your description it is run off of a PTO pump. If this is true then would start investigating...

Were you trying to drive forward under heavy load when this problem occurred? If yes I would suspect the forward high pressure relief...