oldnslo's latest activity

I suspect the weight of a hydraulic driven saw with 20 -24” bar capability would be significantly higher than equivalent gas machine...

This is what I take on this. KTAC paid out for a total loss for some reason, that would give KTAC possession of the tractor. It was...

Just wondering if there is a concern from truck manufacturers about frame strength on 1/2 ton after drilling mounting holes for goose...

Since went through an auction I doubt you have a leg to stand on. If was purchased directly from Kubota dealer with no auction involved...

There are no adjustments on the valve. Some valves have significantly better metering characteristics than others which is what allows...

It is often easier to beg forgiveness than to secure permission. How close are your neighbors, and do you get along with them? Have you...

Does the 2610 have 3 range HST? I thought that was the main difference between that and 2400H or 2800H. Not sure what TYM these would be...

Yes some of the guards make it next to impossible to connect the shaft to the tractor and or grease the U-joint. My Branson also had a...

And they didn't cause accidents, or crash into people headon. The people doing those things were probably the 10% of people that can...

Correct again! PTO relief valve setting is 79 psi.

How deep is the water today? Would a small floating dredge work if you have a place to dump the silt?

Is the 1920 PSI for implement like loader or PTO? I believe PTO operating pressure is much lower like 200 - 300 PSI range but not...

I believe the GC series have a hydraulic operated PTO clutch so first thing I would do is find out how to check the PTO hydraulic...

As they say no good deed will go unpunished 😁 I only have problems like that on days like that end in “y”.