oldnslo's latest activity

If scalping can you have a friend watch what the deck is doing while you turn to see if something is moving in the suspension or deck...

Is that from drive tires skidding during turn or from the deck? Looks like tires in pics but not sure.

Used to be in some states or towns they only had to treat you if unconscious without insurance. Not sure if those rules still apply...

Is the cost of medical due to actual medical costs or the insane premiums for malpractice insurance. A family member years ago said her...

On my 2400H there is a switch on the clutch,PTO lever & seat. Not sure about HST pedals since has switch on the clutch which disengages...

When lifting a load on 3 point what pressure do you see on gauge you have plumbed into the “P” port of loader valve?

I looked at parts breakdown that I have for Rexroth hydrostatic pump and motor. it showed having two fishtails per side on the port...

Richard It has been years since I worked on a motor where the gear case was not a separate item and the two end covers also two separate...

The holes where the impellers are held, I presume. My recollection is they are flat bottom and do NOT go completely through the body...

Does item 8 fit around item 12 the pressure plates. Normally those seals or end separators are held captive in some fashion by a groove...

Relief valves rarely fail closed they typically fail open. Where did you have the shut off valve in relation to the relief valve when...

The three point valve is used to control the height or position of the three point arms similar to how the loader valve is used to...

It sounds like you have a bad hydrostatic pump or drive motor or possibly both since frequently when one component fails it contaminates...

what voltage do you see when engine is running at 3/4 to full throttle? What you are describing almost sounds like voltage regulator...

If my memory is correct there was more than one option on how the choke and throttle were integrated. Can you see what activates the...