oldnslo's latest activity

I suspect the wings would have 1500 PSI and center 2500 PSI. Next time you use this mower mow a distance in taller grass where center...

Dado I suspect cost would be driving factor on if this concept is accepted. Unquestionably the dual spindle will be more expensive and...

How much oil does the tranny hold on that tractor? If 10 gallons like mentioned I would be far less concerned than if it only held 3 or...

Sounds like having a wife.

Where all three relief valves the same part number? Can you take pictures of how where they are in the circuit. Any make and part...

Did you check resistance or ohms on the PTO clutch when you had the wires disconnected? I recently fixed a neighbor’s mower that had a...

Agree don’t look under inflated in that picture. We ran similar pressure with fluid vs without. I would suspect 12 - 15 PSI for a tire...

if center cylinder is extending and retracting fully does the right cylinder also extend and retract? Wondering if the left wing lift...

You are correct on left motor getting flow if right motor is turning Are there any valves in the lines to the motors? Suspect that with...

Does anyone have a hydraulic schematic for the 450 with the hydraulic traction assist - weight transfer system . In watching the video I...

The weight transfer system on the Ventrac/Steiner provides a small amount of lift to the front implement when it is float. This...

Is connecting the lower lift arms causing problems or PTO?

Check for rodents in the intake and exhaust. Mice, bees, etc. like building nests or hives in those areas. Check oil levels in engine...

Best guess is there was a valve like a pressure reducing valve keeping a constant pressure on the lift side of the cylinder supporting...

Bummer, most of us have the FILTHY OLD MEN, but not the RICH. :ROFLMAO: