oldnslo's latest activity

Seems like foxes are attracted to filthy rich old men…😁

Will you be working on slopes or side hills? If yes any estimate on how steep the slopes are? How well the flail works will depend on...

Since asking about spreader I presume you have granuals and in what concentration? I suspect concentration strength and application rate...

You might be money ahead to buy a different tractor to run that mower or get a pull type mower for your 806.

How to turn a fox into a dog ?? . . . . . Marry her.

Not sure but would 856 or 866 arms work or possibly 1006 or 1056, etc. Not sure where you are located but have you looked at Worthington...

piece of 15/16 or 24 mm rod weld head on one end drill hole for hitch pin on the other or like stated a bolt depending on what you can...

HST trannies are not my favorite for much of anything. I've used and ran large old Hydro's IH656,1026, hydro100 when they were new...

I suspect that is part of the confusion on the thread. What HP tractor are we talking about being used for what purpose or purposes...

If dropping at low idle sitting still I would suggest checking both pump and motor case temps. Not moving motor in theory should have...

To the best of my knowledge yes that is still a semi common feature. I believe Deere 2,000 series, some Kubota B series and BX series...

The looped lines will show charge pressure in neutral and should have minimal change if trying to drive If trying to drive rear wheel...

Smaller CUT tractors with dual range HST have an issue of significant gear increase from HST to rear wheels in high range so they really...

The enable valve is supplied by the Ps port and will operate with the “G” port capped off. Ps is the pilot pressure to the pump control...

The name plate is a Rexroth product and description fits the A30. Pump was manufactured 36th week of 2017.