Recent content by Oldie68

Hi sorry let me attempt to be clearer. I first lifted the front wheels (actually all of them engine running put it it gear in 4wd, only right rear was turning nothing at the front wheels, could turn either front wheel in either direction no resistance and no alternate action from the opposite...

Needing some help with this. 4wd seemed to be working when I got this li'l beast. Not it definitely is not. Pto shaft coming from transmission turning, splines on shafts although worn a bit are good, when I disconnected shaft and or before I could turn each front wheel independently, with...

OK, I did this I got between 2-3 maybe 4 V AC on the 50 volt scale (not good at reading those analog meters), no matter which way I connected two of three wires to meter.

Hi all just wondering if anyone knows where to source the best prices and selsction for rear tires for a Kubota B6000. i thinnk this little unit still has the original Bridgestone "rice paddy" style AG tires on the rear. It's a 4wd and has Carlisle AG's on the front as well. When replacing the...

Hi all, new here. Recrntly acquired a B6000 with a fel and a backhoe. Found fan-belt had been replaced but somebody didn't reinstall the tensioner. When I figured this out and sort of got some tension on the belt, I see from motor running charging system doesnt seem to be working. Only 11 volts...

Hi all there may be somewhere my questions answered on here but asking for help anyway. From what I can determine after recently acquiring this little unit c/w fel and small backhoe. I've posted some pics of the unit regarding another topic as well. I think it a 1973-1977, range. My charging...

I hear ya. Anyone know the output in volts of the dyno at any of the 3 wires. Then maybe will have to verify the rectifier condition

No, i didn't do anything rough that would have broken anything but the previous owner/s probably did n then attempted to cobble it to work but not very well.

what's your email it might be a bit easier to send pics that way. Argh!!!

I hear ya there. Well on mine there doesn't seem to be any splines (unless the morons before me did something), I'll take a pick and try n send it ans what I did to fabricate a locking mechanism.Maybe my steering wheel isn't even the one for it, but it works gooder now.

Now that it's warmed up a bit. I had the opprtunity to remove the steering wheel, and cobble a locking means to stop the wheel from spinning on the shaft under the centre nut. There is no spline on this shaft, but under the hub there are some flutes. I ended up cutting a piece of 11/2 " pipe and...

Is/are there rebuild kits as well as bearing kits availbke for this engine.