Menu
Forums
Today's Posts
New posts
Search
Members
Current visitors
New profile posts
Search profile posts
Top Posters of the Month
Classifieds
Auctions
Database
Quick Review
Quick Owner-Page
Register
Log in
Join
What's new
Search
Search
Search titles only
Today's Posts
New Posts
Search
Members
Current visitors
Top posters of the month
Menu
Log in
Join
Forums
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
nyone's latest activity
N
nyone
replied to the thread
I've been had! Well,........ manipulated!
.
VRBO has been good for the 2x I have used them. Once for a 2br cottage by the beach in NJ and one for a 2br place in the lakes region of...
Aug 5, 2025
N
nyone
replied to the thread
Pond dredging
.
make a suction jet pump. Parts are prety cheap and it's going to be way cheaper than a long reach excavator.
Aug 5, 2025
N
nyone
replied to the thread
Streering wheel and shaft comes loose
.
While your in there drill a drain hole in the steering tube. Mine was filled with rusty water and crud. The steering valve seal is...
Aug 5, 2025
N
nyone
reacted to
KWentling's post
in the thread
2014 BX1870 Steering Frame Broke
with
Good Post
.
My guess it happens when one uses the steering wheel to pull yourself up on the tractor. My wife does that on our BX22. I've replaced...
Aug 1, 2025
N
nyone
replied to the thread
Help with identifying yellow Post hole digger
.
I guess you arnt reading any numbers off the bearings or seals?
Aug 1, 2025
N
nyone
replied to the thread
How much ballast for a 40hp machine (TC40DA)
.
Load the rear tires. Idk how people drive machines that have loaders and no weight on the rear. Also 3pt balist is cheap but it sucks...
Jul 31, 2025
N
nyone
replied to the thread
2008 TC40DA loosing power
.
Blow the fuel line back into the tank. Also dont go by the gauge. My tc40 shut off on my climbing a pile. Then the key wouldnt do...
Jul 31, 2025
N
nyone
replied to the thread
Heat Pump Mesh Cover, anyone with experience?
.
Be carefull with a mesh cover as you may just end up with packed snow behind it.
Jul 30, 2025
N
nyone
reacted to
repete's post
in the thread
What is good in trailer tires?
with
Good Post
.
I do the same. I have three towing trucks so any type of electronic setup would be challenging. Those point and shoot thermometers work...
Jul 28, 2025
N
nyone
replied to the thread
TC33DA - adding oil slowly to avoid engine damage?
.
Just did the oil change on my tc40 yesterday..and it didnt blow up. I just used a small funnel and greased the unit while I filled it.
Jul 27, 2025
N
nyone
replied to the thread
What is good in trailer tires?
.
I log at least 3,800mi towing per year. Alot more than 1,000mi in 6yrs. I'm just carefull about not pulling over on the shoulder, not...
Jul 27, 2025
N
nyone
replied to the thread
Where to go for rear tire replacement???
.
I have changed them my self. Sledge hammer, few prybars and a jug of soapy water. I have calcium filled tires so needed a liquid fill...
Jul 27, 2025
N
nyone
replied to the thread
How do you clean your greasy loader pivots?
.
I have done this and it tends to blow appart the grease but then spreads it all over the machine. What's the best way..idk as I dont...
Jul 27, 2025
N
nyone
replied to the thread
TC29 Buying with Transmission Issue, Pass or Risk It?
.
unfortunately with these auctions you generaly have to pay then go see what you bought. I would pass on this. It will prob come back...
Jul 25, 2025
N
nyone
replied to the thread
Trailer TPMS
.
I have family who put aftermarket TPMS sensors on a RV. It had rubber valve stems. In a years time they had to replace all 6 valve...
Jul 25, 2025
Forums
Top