nyone's latest activity

Cheap, black and round..they also need to be radial and hold air. In 8-10yrs your going to need to replace them anyway. I run just...

Dont throw parts at it. Test things like you have been. There may be a clutch switch and PTO switch. You could try to jump power to...

That's not that hard. It's not a high speed bearing or roller.

As long as there tight and make good contact with the flat part of the eyelet the nut is really there just to hold it, not so much of a...

Express steel and tomahawlk both make quality USA built grapples that are strong enough for a large machine like yours. I would...

becids cheap parts I dont see this thing worth fixing. Your not going to replace the engine or generator.

"As short as possible" then types out a novel. Lol If you have 13v when running your charging system is good and I suspect you have a...

The longevity of any road will be greatly Iincrease the faster you can get water off it.

Could be some junk in the tank clogging the outlet. Next time it's happening instantly take off the fuel line right below the tank and...

That's a good catch. Now why did only 2 of the 4 brakes lock up?

I should note too that I have used rustoleum in a HvLP spray gun on a few bilco doors and have to re paint about every 8yrs. They get...

I have used this one to spray 5gal of water based poly on pine tongue/grove and trim. No thinning and no issues.

Theres no acess cover? If so spray it penetrating oil and try to free it up.

I use to cut chain link fence lines with a boom mower like that. I dont see why you couldn't with a side flail.

It's only a tractor so prety minimal pannels to move and you have acess to nearly every wire on the machine.