number two's latest activity
-
Nnumber two reacted to bowenskye's post in the thread Grease - is there no better way? Can we talk about this? with
Good Post.
I leave the canister, that holds the grease tube, a little loose, so that air can escape. -
Nnumber two reacted to kneedeep's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
Most GG have a button or a bolt that will ‘burp’ the air out. During hot weather, I keep mine in a bucket upside down as the heat will...
-
Nnumber two reacted to JimR's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
Do not tightened the outer tube all the way in. Release the spring operated rod at the bottom. The air in the tube will purge out. Then...
-
Nnumber two reacted to dkmc's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
I'll answer that.....Way oil......except real way oil has gotten very expensive. I've seen mention of 'bar & chain' oil and always...
-
Nnumber two reacted to Reapoman's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
Grease is like diesel fuel. You cant get within 50' of either without getting it all over yourself.
-
Nnumber two reacted to Lena's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
grease or new parts $$$. I will take grease anytime no matter how messy. besides it shows anyone that sees it that I care about my...
-
Nnumber two reacted to Crank Shaft's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
I also store my grease guns in a 5 gal. bucket and am surprised at how much oil leaks out of the grease and collects at the bottom of...
-
Nnumber two reacted to ptsg's post in the thread Kubota BH75 bent bucket cylinder rod with Good Post.
I also bent the bucket cylinder on my homemade excavator. Granted, it was kinda of a dumb stunt while fighting an huge eucalyptus tree...
-
NI have purchased two tractors, mini ex, and skid steer from Ginops near Traverse City. Saved thousand on each typically 10K even with...
-
NNo, it was a mower for a local state college, they apparently had there own mechanic(s), while I was at the local Kubota dealer the lady...
-
NHaven't used it in over 10 years ... But it still follows me around ...
-
NThe Monster Maul! That thing is almost as old as you are! And the best splitter I ever used this side of a hydraulic one...
-
NIf you look closely at how the wheel is built, it has a "ring" or pipe welded on to the center section in places that bolts go through...
-
NI have had loads of fun shooting chipmunks this year while sitting on the front porch having my morning coffee. Typical range is...
-
Nnumber two reacted to Roadworthy's post in the thread kubota b1550 front axle u-joint with Good Post.
Take it to a vehicle drive line repair shop. I don't mean Auto Zone I mean a place that can actually repair or build a drive line...