number two's latest activity
-
Nnumber two reacted to CalG's post in the thread Kubota front axle, hydraulic fluid or gear oil? with
Good Post.
Except ...I have read...... UTTO Prolongs seal life over gear oil. So if you don't need the EP properties of sulfur, Go UTTO! I use... -
Nnumber two reacted to repete's post in the thread how much gear oil for a woods RC-5 rotary cutter? with Good Post.
80-90 vs 75-90, not difference in my mind. The fact is it is going to really like regular changes with clean grease. I have for years...
-
NI do the parking cone funnel at work for the diesel generators… can’t spill a drop because spills trigger reporting and mitigation.
-
NI've never seen a small aircraft without a fuel sump under the tanks. It's at the low point. You push a glass tube up under it and drain...
-
NI bought new pour spouts for all my new gas and diesel jugs. Drilled a 1/2" hole in the jugs and added the vent in all of them too...
-
Nnumber two reacted to KubotaGuy810's post in the thread Kubota B3350 wont start.... AGAIN with Good Post.
Ran a wire from ignition to starter and starts up just fine. Got it back to the shop. Now it'll be easier to check all the safety...
-
NRepaired dozens of stripped sparkplug hole threads back in the 1970's while working at an independent Volkswagen repair shop. First you...
-
NParticularly necessary in aluminum heads. The Al/Fe differential expansion "works" the joint. A little piece of aluminum cracks loose...
-
NAll you have to do to chase those threads is put some good old axle grease on your tap - and even if you were to get a tiny bit of...
-
Nnumber two reacted to Davenj4f's post in the thread Best Way to Clean up Zero-Turn Seat? with Good Post.
Regardless how you clean it, I always rub Neatsfoot oil into my seats of vinyl, or whatever they're made of, to keep them from drying...
-
NA pto shaft with a plain u-joint on each end works best if the angles of each joint is equal. So, with the hitch pin near the center of...
-
NIncorrect. It requires equal co-linear AND co-planar alignment of the input and output shafts, with the center of the intermediate...
-
NMy 2020 MX6000 just completed 5 years of use with 1250 hours on the meter, so 250 hrs/yr. Use has slowed now that the jungle has been...
-
NJohn Deere 5045E bought new in 2021 has 592 hours. Used for maintaining 20 acres, food plots, garden, mowing, firewood harvesting, and...
-
NA caution about removing PTO shields. Years ago a friend was feeding cows, roundbales on a 3pt carrier.. Hung the string on the tail...