Recent content by mmsb27

I have to clean everything (spreader/tractor) after spreading lime, and or fertilizer. Or else corrosion starts. Better to clean, than fight corrosion.

I have the Echo 590 Timber wolf. Great saw.

Another happy Echo CS 590 Timberwolf owner/user. I love this saw.

I ended up putting in ten quarts. I’ll run a while and recheck. Thanks for your help

Thanks Willy. I put 8 quarts in with a new filter, and it’s not even half way between the low and high. That’s why I’m confused. I don’t want to over or under fill it. When I drained it, I measured as best I could what came out at almost 9 quarts. Before draining, I check the oil level and...

I have a 2006 Farmtrac 550DTC tractor, it’s the Korean made by LS model, not the Farmtrac that looks like a Ford. It’s has a 4 cylinder Mitsubishi Diesel. I hope I can attach the photos from the top of the engine. Here’s where I need help, I can’t locate my manuals for it. I don’t recall the...

thank you!

Thank you very much!!

Hi Anyone know of an online Kioti parts dealer? Dealer I bought my Kioti stocks few parts. Other than Kioti oil and fuel filters he has to order parts for me. Besides the time delay, I get charged the shipping and handling to his dealership location, then add on several hours of my time to...

OP, any updates for us? Thank you

Inquiring minds want to know!

They are 1 7/16” nuts, the axles are 1” square. Since I felt the axles should spin freely like a roulette wheel, I was concerned I might have over tightened the nuts. I’m glad to hear that being very tight is the correct way. The axles spin, but only as I turn them. I imagine as others...

Thanks Ken. I was concerned about over tightening, thinking I could somehow stress, or impede the bearings. The axles each have a nut, and then a nylock(sp?) nut. I bought new Nylocks. After I use it a bit, I’ll check tightness, and snug the new ones on it. Thanks for your help

Thank you very much! I appreciate your advice.

Thank you very much. All 4 gangs spins, the rear two spin easier(freer) than the front two spin, but none are like spinning a something lubed. No noise, or bad bearing sounds. In other words I can turn them by hand, but not give them a spin, and they keep turning a while. I’m assuming that’s...