I helped a buddy hook up a new front blower to a BX24 last weekend and I'm seriously considering purchasing a blower for my B2910. The hydraulic lift setup is sweet for the BX24, but for the life of me I cannot figure out the configuration of the lift mechanism for a B2910. The only reference...
I donw't know if this is the appropriate forum to pose this question, but here it goes....
I'm thinking about purchasing 3 pt forks from sundown, but I don't know the lifting capacity of the 3pt hitch.
Does anyone have any experience using the 3pt for this type of application...
A friend of mine lives in northwestern New Jersey. He has a gravel driveway that is approximately 750 feet long and has a change in elevation of 300 feet. His house is located at the top of the "hill." It currently takes him about 4 hours to clear the snow using a heavy Troy Bilt blower (I...
My guess is this question has been asked multiple times, so please have some patience with me...
An individual is selling a Kubota B2782 (63 inch) front mount blower with the optional hydraulic chute rotor. I would mount the unit onto my B2910 tractor. The unit has been used a total of 4...
I'm sure the topic has been beaten into the ground, but I figure I'd ask it again - what is the concensus on the use of OEM (in this case Kubota) filters versus WIX filters (engine, hydraulic, transmission) - opinions, warnings, accolades, etc.
A buddy of mine "destroyed" his BX22 tranny. The dealer thinks the damage may have been caused by locking the differential while the rear tire was engaged or moving. According to the dealer, the gears ground up, and the metal got lodged causing the housing to buldge outward, and it cracked the...
I know the SUDT oil question is beaten about regularly... but my question concerns engine oil. I'm running a B2910 and its time for the regular 6 engine oil change. What is the concensus - Kubota branded oil or a substitute? And while we are at it, if a subtitute is recommended, what is the...
Winter is over here in NY State, and spring is knocking. Time to perform the maintenance, including (but not limited to) draining the hydraulic oil and swapping out the filters in the rear. But of course, I have forgotten (getting old stinks) which hydraulic filter goes on the right side (and...
Does anyone have an opinion concerning the value and utility of a core aerator? I am looking at either the Land Pride CA25 Series Core Aerators (60 or 72 inch) or the Woods/Gill pl60 or pl72 aerator. I have a B2910 and I would be operating the equipment of a former (flat) cornfield turned lawn.
Does anyone know where I can find or fabricate a "thumb" accessory to install on a 4690A backhoe (mounted on a B2910)? I have quite a bit of brush, sapling and dead tree limb debris to clear. I am looking to avoid welding if at all possible.
Yet another question. The coolant in my Kubota B2910 is scheduled for replacement. The manual directs the use of PT (Permanent Type) antifreeze.
Can I use an antifreeze such as Prestone or Zerex, or do I need a low silicate formula similar to the antifreeze that is required for a diesel F350...
I have a question concerning the change interval of the Hydraulic Fluid on my Kubota B2910. I do not have many hours on the tractor (122 hours). The fluid was changed at the 50 hour mark. Should I base the change interval on the number of hours as specified in the owners manual(300 hours), or...