Recent content by ldammeyer

My ford 2000 is giving me fits. The entire due system has been replace: new lines, new filter, new fuel pump. Ran good for two cuttings of Hay and then just quit while I was driving it.....hasn't started since. They guy who helped me get it going this last time said the Holley carb from 1970 is...

It has been one thing after the other with my 3 cylinder gas burner this spring/summer after running like a top for years....so here goes. Earlier this spring I went to start my tractor and it would not start - valves were stuck from not putting Stabil in gas over winter. After fixing and...

It has been one thing after the other with my 3 cylinder gas burner this spring/summer after running like a top for years....so here goes. Earlier this spring I went to start my tractor and it would not start - valves were stuck from not putting Stabil in gas over winter. After fixing and...

Have a 1970 3 cylinder Ford 2000 gas burner. Have had a fuel starvation issue and local New Holland / For dealer suggests I put an in-line electric fuel pump between tank and carb and block off old diaphragm pump. Any suggestions or does anyone know what PSI I should be shooting for? Was...

My Ford 2000 gas 3 cylinder stated running really rough - after investigation I found # 2 cylinder had no compression. I took off the valve cover and discovered it has a bent push rod. I can tell the bend is well down toward the tappet, but have not pulled out the push rod. The push rod rotates...