Recent content by LarryS

Agree, no power down. Gravity only.

I once had a car that had a broken battery post. It was broken just inside the case. It'd die at a traffic light but wracking it on the post made enough connection to get going again. I had another vehicle with a mysterious die-while-driving malady. To troubleshoot that I made a test light...

N8QNM here. Never thought to mount a 2m mobile on my tractor. Wouldn't be of much use here since you can holler from one end of the place to the other due to the low signal to noise ratio out here. But if I took the tractor someplace else it could be a real benefit. Larry N8QNM VE and K2BSA...

I have a Nimco CV422 loader valve (no PB). I looked up the part numbers and found: O ring/spool seal part number of 71513155 which Jack's sells for $49.40 complete seal/set kit part number 71512160 for $46.27. I have a hard time understanding why the spool seals cost more than the entire...

OK, I've checked the past posts and I've lurked here many years. I've been checking the AGCO part books and each time I navigate to the right point in the directory structure, I see the lines: GC2300 / GC2310 TRACTOR EFF. S/N JNA25201 GC2300 / GC2310 TRACTOR PRIOR S/N JNA25201 Now I go look...

Buddy of mine was lifting manure with a Koyker FEL with a custom bucket extension and broke his clutch housing. It was a treat to take apart the FEL in the pile and horse the two halves onto a flatbed. We ended up using a come a long to keep the front and back axle halves together. My question...

Gentlemen: I have a problem with my GC2300 MMM not lifting on one side. I have the adjustments set all the way they can go and still the left side barely lifts. There are two potential problem areas: one is the front mount only having one pin. It looks like the pin in the left side of the...

I have a GC2300 that has a bent FEL bucket. The 17 year old was using it for snow removal last winter and had the bucket bottom vertical like a plow. Long story short, it's bent about a quarter inch. Just enough to make cleaning out the pens annoying. Any thoughts on how to straighten this? Do...