kennyd's latest activity

Yes, you could. Would need longer bolts later however. These are Bucher valves, top of the line stuff...

While more money... You can also get a 'stack' valve where you custom pick each spool, and make the 3rd one electric so you can plumb it...

Check for voltage at the solenoid first while activating the button. But ,I suspect the spool in the valve body is stuck from lack of...

I'd guess poor manufacturing tolerances or excessive powder coating on the holes. Just ream the holes a bit and the pin should slide...

Wow, just seeing this @dicktill , hope it gets taken care of quickly!

old gc2400 was instrumental in building 4 tomato trellis, each 8ft long and hinged for storage. used tractor to haul the lumber up...

Started out this morning with lifting the Z-TRAK up to touch up the blades ... Then had to rescue the John Deere due to operator...

You should have a "timing bar" between the two bucket adapters. This bar that straddles between the two frame members keeps the two...

Last night shortly before coming in from my creek project I noticed the BH control tower was wobbly, rocking forward and back, this...

Got another 650 gallons of water out to the trees today ... Takes about 50 minutes running the well and garden hose to fill the trailer...

I then came down to the garage for some maintenance on poor Little Baby Fergie ... A few weeks ago I was out watering and was backing...

I have been looking at them for years, had planned on building one, but unfortunately, I needed one pretty quick and didn't have the...

If it sticks, I just tip it upside down and just tap it on the ground ... Gets "most" of it out ... One thing to be aware of...

correction, PTO pump.

"Attention: Suction lift not to exceed 3 feet." You can look for "lift pump" or "sump pump" to fill other containers to supply this...